best spinning bike 2011 image
Paul scott
its a 2011 mirraco bronson, fully sealed bearings. i pack the hub with grease, but it still does the same thing with out grease. my chain is not tight, but doesnt have much slack either.
what can i do to fix this?
Answer
You could have tighten the cones too tight when you packed the new grease. You will have to undo until you get it right, or the cones have been pitted in which case you will have to replace them.
You could have tighten the cones too tight when you packed the new grease. You will have to undo until you get it right, or the cones have been pitted in which case you will have to replace them.
Brakes and Tires Replacement Honda CBR125R 2011?
Brenton
Hi guys i was wondering when i need to replace my brakes and tires on my bike? On what mileage or how do i check the condition?
Answer
with the tred on the tyres there should be a little blob of rubber in the tred to indicate the minimum tred line, if this is flush to the top of the tred then youll need to change them and for the brakes ( disk brakes ) then you can just look at the disk and you will see the brake pads touching it, they should be 3mm to 10000000000mm if any less then i would change it, if you spin the wheel and hear a scrraping noice then it could need changing
with the tred on the tyres there should be a little blob of rubber in the tred to indicate the minimum tred line, if this is flush to the top of the tred then youll need to change them and for the brakes ( disk brakes ) then you can just look at the disk and you will see the brake pads touching it, they should be 3mm to 10000000000mm if any less then i would change it, if you spin the wheel and hear a scrraping noice then it could need changing
Powered by Yahoo! Answers
No comments:
Post a Comment